Bearings, Shafts, & Spacers

#10-32 Standoffs are compatible with the REV ION System and provide spacing for mounting key items on your robot. These standoffs are tapped on each end for a #10-32 thread and have a 3/8in flat to flat dimension, similar to a #10-32 nut...

#10 Spacers are compatible with the REV ION System and are an accurate way to space structural components like plates, brackets, or tubes apart on #10 screws. Can also be used to to space motion components like gearboxes away from their mounting...

#10 Spacers are compatible with the REV ION System and are an accurate way to space structural components like plates, brackets, or tubes apart on #10 screws. Can also be used to to space motion components like gearboxes away from their mounting...

#10 Spacers are compatible with the REV ION System and are an accurate way to space structural components like plates, brackets, or tubes apart on #10 screws. Can also be used to to space motion components like gearboxes away from their mounting...

#10 Spacers are compatible with the REV ION System and are an accurate way to space structural components like plates, brackets, or tubes apart on #10 screws. Can also be used to to space motion components like gearboxes away from their mounting...

The 1in Pivot Joint is compatible with the REV ION System. Create a pivot joint at the end of a piece of MAXTube - 1x1 with Grid Structure. Specifications Material: POM (Acetal/Delrin) Documentation REV ION Build System Documentation Introduction...

#10-32 Standoff Stock is compatible with the REV ION System and provides the ability to make custom length standoffs for mounting key items on your robot. The standoff stock has a 0.159in hole through to allow users to tap on each end for a #10-32...

The 1/2in Rounded Hex Shaft is a ready-to-use length of hex shaft that has been cut to length and the ends tapped. The ends are tapped 10-32 in order to accept a screw and washer or shaft collar. The 1/2in hex is compatible with the shaft retention...

1/2in Rounded Hex Shaft - 36in (not tapped) are compatible with the REV ION System and are a ready-to-use length of hex shaft that is compatible with the shaft retention method of the MAXPlanetary output stage. The 1/2in Rounded Hex Shaft -...

The 1/2in Rounded Hex Shaft is a ready-to-use length of hex shaft that has been cut to length and the ends tapped. The ends are tapped 10-32 in order to accept a screw and washer or shaft collar. The 1/2in hex is compatible with the shaft retention...

The 1/2in Rounded Hex Shaft is a ready-to-use length of hex shaft that has been cut to length and the ends tapped. The ends are tapped 10-32 in order to accept a screw and washer or shaft collar. The 1/2in hex is compatible with the shaft retention...

The Elevator Bearing Block is used to assemble a mechanism, allowing two pieces of rectangular tubing to slide in relation to each other in a linear motion. This bearing block is designed to mount to the narrow side of rectangular tubing with a...

The Elevator Bearing Block is used to assemble a mechanism, allowing two pieces of rectangular tubing to slide in relation to each other in a linear motion. This bearing block is designed to mount to the narrow side of rectangular tubing with a...